This is usually a 2 person task.
How to fish electrical wire through floor.
Bend the wires over then wrap several loops of electrical tape around the wires and the end of the fish tape.
Pull the cable through with a fish tape.
Attach the wiring in the 3 by 5 inch hole to the end of the fish tape.
Tape the end of the fish tape tightly onto the cable with electrical tape.
Now you should be ready to fish the wire.
Carefully extend the fish tape from one opening to the other.
Make sure the tape is smooth so the cable can slide through the opening.
Strip about 6 inches of outer sheathing from one end of the cable then hook the conducting wires and bare copper grounding wire through the loop at the end of the fish tape blade.
Then retract the fish tape to pull the cable through.
Run the wire or cable to its destination.
Pull the wiring through the wall by reeling in the fish tape bringing it out through the hole for the electrical box.
Even though cables are insulated the high voltage current can interfere with the signal in the low voltage wires.
Pull an additional 2 to 3 feet.
Separate the wires within by bending two of them back and leaving one still standing.
Attach the wire or cable to a fish tape or coat hanger using electrical tape and feed it into the hole until it reaches the opening at the other end.
Reel and wind the fish tape which will pull the electrical wire along with it as it snakes through the wall and ceiling.
If you re working from the attic you can drop a weighted string down wall cavity then attach the wire to the string and pull it through.
Run electrical cable through walls and across ceilings without tearing them apart.
For more in depth informatino about running fis.
Have someone at the other end reach through the hole in the drywall grab the fish tape and pull it through with about a foot sticking out of the hole.
Learn how with this video.
Then tightly wrap the electrical wire cable with electrical tape from the point that it is connected to the fish tape to just past where the other wires are bent.
Bend the lone wire through the loop end of the fish tape and twist it so it won t be pulled off.
It s really tempting to fish low voltage wires like coax and cat 5e through existing holes occupied by electrical cables but don t do it.