Once this is done measure and cut out your pieces of laminate to make tread pieces riser pieces and stair nosing.
How to fit laminate flooring around stairs.
Personally i don t like beading so i suggest fitting re fitting skirting boards when fitting solid wood flooring but laminates i give a 2mm gap around all the way around and not one has ever expanded.
This means that where you would normally put beading scotia around the outside of the room to cover the expansion gap in the case of the bottom step of carpet the carpet is trucked into this gap.
Laminate flooring is an economical way to get the look of genuine hardwood at a much lower cost.
The riser must come flush with the surface of the tread and the stair nose which goes on last curls around the top of the riser and either fits flush against the laminate.
You have to ensure that there are no gaps and spaces in the flooring and it is complete and perfect in every way.
Stairs are one of the largest surfaces in your home and choosing what material to cover them with has a big effect on the look and feel of your space.
Cut a laminate piece to fit against the face of the riser to complete the effect.
Laminate flooring installation on stairs.
To install laminate flooring on stairs start by removing the overhang or the underside of the stairs with a jigsaw.
You need to take care of the treads risers and stair noses which can get a bit complicated at times.
The international building code specifies a maximum riser height of 7 inches so a single laminate plank usually suffices but you may prefer to use pine poplar or some other stainable wood instead.
Hi the carpet is fitted into the expansion gap of the wood floor round so i always fit the laminate first.
Here is an easy trick how to install hardwood or laminate flooring around curved walls.
Repeat this with each step.
However installing laminate flooring on your stairs is a completely different matter.
Cut and install the 90 degree corner trim on the edge of the step for a finished look locking it into the groove of the laminate pieces around the spindle.
Around the stairs i profile it around the stairs with 1mm 2mm gap which carpet on stairs covers.
How to install nucore flooring on stairs installing laminate around spindles in regards to the scratches on this delicate flooring i forgot to mention the installer replaced a few planks because the rubber mallet caused dents even though i watched him install and saw no abuse of the material when installed.
Alternatively you could cover the overhang with plywood to make it level.