Let the wood sit for a minute or two to absorb as much moisture as possible.
How to fix dents in finished hardwood floors.
Apply more water cloth and hot iron if the dent is still there.
High heeled shoes leave a trail of small dents in the wearer s wake and ruin the smooth look of the floor.
Clean the area around the dent and make sure that it is free of any oil dust and dirt.
Give the water time to soak into the wood.
Before you begin though you must check with your floor manufacturer and verify the melt stick color compatibility with him.
Press it to the dent and apply the tip of a hot clothes iron.
Once you apply heat to the spot the wood will expand and the dent will lift right out.
Dents happen when something heavy or blunt strikes the wood hard such as a baseball or even dishes that are dropped and broken.
If you take a chunk out of the floor you ll have to fill the divot with wood putty then sand stain and finish with urethane making sure it blends with the rest of the floor.
Make sure there is a lot of steam being generated.
Select the wax stick that matches the color of your floor after having discussed it with your manufacturer.
But you will may have to remove the finish first if that first method doesn t work.
With the iron on high apply the iron to the wet paper towel or cloth and make a circular motion don t keep it in just one position as this might burn the surface of the towel.
It should swell the dent back up to the surface in most cases.
Repeat adding pressure with the hot iron.
This is basically a prefinished hardwood floor filler melt stick.
Steam causes wood to swell and rise to meet the rest of the floors surface.
1 clean the area around the dent of oil dirt and dust.
Dents occurs on hardwood floors from something heavy dropped on them or a more common culprit high heeled shoes.
Use a pin to poke small holes in the bottom of the hole through the finish.
Apply a wet cloth or paper towel 3.
As the water seeps into the wood it will cause it to soften and become pliable.
With a few simple tools dents can be filled and the surface blended to match the surrounding wood color and grain.
Check the dent and continue adding water cloth and heat until the dent is gone.