Wipe the surface with the vinegar solution rinsing the mop cloth frequently.
How to get marks off manufactured floor.
Wipe the scuffed area slightly with a damp sponge.
Avoid using a hardened or older eraser to help prevent further scuffing.
Eraser this can be done using the regular eraser of the pencil however there are also special hard rubber erasers available which are designed to clean the floor especially that they are able to work best on the marks.
Pour small amount of hydrogen peroxide onto a plastic cup.
With a more porous natural stone surface over wetting should be avoided.
Allow the cloth to remain on the stain for ten minutes.
Lightly rub the stained area with the steel wool blending with light rubbing on the unstained areas of the floor.
Dip the nub of soft eraser in the soapy solution and rub on the scuff to break up the material.
Take care to not press too hard as the goal is to remove extra wax from the floor while the wax in your newly repaired scratch remains intact.
Soak a clean rag in the vinegar placing it onto the stain.
In a small bowl make a dilute soapy solution with water and a mild neutral ph soap like dove.
The moisture and pressure may be enough to rub away the scuff.
If needed use fine grit sandpaper to gently buff the area.
In case you re uncomfortable with the white marks on your wood floor use the following simple procedure to get rid of them.
As a caution this can result to dulling of the protective finishes if it is done with repetitive use.
After scrubbing the spots you can then remove them from the floor with a clean pass with your rag or mop.
Use a clean cotton cloth and lightly wipe the floor to clean it after you repair any scratches.
The first step is to use sandpaper to lightly sand th.
One way to remove tape marks is to sand the sticky surface stain and seal.
This will allow you to really attack the smudges and smears with a soft brush or with a wet rag.
Wet your mop or soft cloth into the solution then wring out to remove all excess water.
Rub a pencil eraser.
Tape reside or tape marks left on a hardwood floor create a dark area due to debris clinging to the sticky surface.
Soak a cotton pad inside the hydrogen peroxide place the wet pad on the white marks and allow it to soak in the wood to bleach out the stain.
Feathering the area in this way will help with future refinishing and staining.
Apply the wood wash with a mop or apply it while on your hands and knees.
Wipe the water off the wood with the dry portion of the towel.