Gather your broken pieces of ceramic together and put this glue to action to witness this amazing ceramic glue in action.
How to glue ceramic pieces together.
When you break a ceramic vase or plate it doesn t have to go into the trash you can often glue the pieces back together seamlessly.
Polyvinyl glue also wipes off easily so it does not ruin the outside of the ceramic.
As you stick one piece hold it tight and let it dry.
How to glue ceramic pieces back together.
Now you should first assemble the pieces to be glued together like a puzzle without using glue.
Apply the epoxy or super glue to the end of an ice cream stick and dab the adhesive onto one of broken edges then press it into the corresponding edge with light pressure.
Epoxy or super glue for ceramic or sculpture repair.
Step 4 repeat to apply glue for other parts as planned.
This will give you a good overview of the different parts.
Allow the adhesive to dry completely according.
Now using the popsicle stick or toothpick apply glue on one side of the broken piece and join the piece together.
Use only as much glue as needed because using too much glue can cause the repair to look crooked or make it difficult for the broken piece to fit properly.
Best tools to glue ceramic pieces back together.
An old piece of perspex mix a glue on sandpaper to roughen up the edge of the ceramic that you are gluing duck tape keep the two parts that you re gluing together whilst the glue dries a scraper to trim away the excess adhesive.
Hold each piece in place until it s stable then release it.
For best results gorilla recommends clamping the pieces you are gluing together and leaving for 1 2 hours for the glue to dry you will then need to leave it for 24 hours to cure.
Meaning if clamping too hard the epoxy will squeeze out which will then make it.
Then move on to the next part.
After surface cleaning apply the ceramic adhesive according to the manufacturer s instructions.
Epoxies require some body thickness between broken pieces to be effective.
The best way to glue ceramics back together is by applying glue with a brush.
If the broken pieces do not have a perfect fit epoxy will fill in the gaps while creating a bond between the broken pieces.