You can attach the transition in one of two ways.
How to glue down floor transition strips.
Loose transition on a teragren floor can be a problem.
Step 6 use a damp cloth to remove any excess glue.
Use construction adhesive if you glue it and 2 inch finish nails if you nail it.
Step 2 apply a 1 4 inch wide line of construction adhesive to the bottom of the transition strip where it will rest on the concrete.
Place the transition strip in the expansion joint and press down firmly.
You can glue it to the floor with liquid nails or you could use the track that comes with it to attach it.
Drill 1 8 inch pilot holes for the nails.
Then press it onto the floor.
Step 7 place several large strips of painter s tape across the t molding to hold it down while the glue dries.
If you are using liquid nails apply a bead of the liquid nails to the underside of the transition.
However if this happens to your floors read this blog to find out how to repair it.
Do not glue the lips to the floor.
Because it is attached to neither floor each floor can expand and contract without cracking the transition strip.
A seam binder is installed by simply positioning the strip over the seam then driving screws through pre dilled pilot holes in the strip to secure it to the subfloor in the gap between the floors.
Apply a 1 4 inch bead of flooring or construction adhesive along the center of the expansion joint.