Cut a few small strips and lay them on top to decide where you want them.
How to hang a rug with fringe on the wall.
This method allows you to hang a fringed rug on the wall without damaging it.
For extra support hammer nails into the corners.
The second method of hanging a rug should be used for large and heavy weight rugs.
Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug.
Insert a suitable rod.
Hanging heavy weight rugs.
Insert rod into the tube of fabric on the rug and hang the rod onto the wall.
To hang a round rug on the wall you would use push pins or command strips.
This should be attached close to the top of the rug.
Place the fringes on one end of the rug between two slender pieces of wood e g 1in x 1 in that have been cut a few inches wider than the rug.
Hot glue a strip of the cotton fringe right along the long bottom edge of your rug.
To protect your rug from the wood and nails paint or seal the rug strip and let it dry completely.
Put the top of the rug there and put a push pin or command strip there.
Attach the tape to the back of the rug in the same way as for a smaller rug.
Since you ve already measured your carpet tacks to the length of your rug you ll want to place the strip where the top of the rug will sit on your wall.
This will serve as casing for your rod when hanging the rug.
Attach rod support the brackets to the wall aligned with the gaps in the.
Hanging fringed rug on wall.
First mark where you want the rug.
Line up the carpet tack strips where you ll want to hang the rug and gently hammer the nails into the wall.
A heavy cotton casing may be sewn onto the back of the rug again this should be hand sewn if hanging a handmade or antique rug to form a tube through which the curtain rod may be inserted.
Sew fabric to the top of the rug forming a tube.
Then pin the bottom.
Using a level to ensure the strip is entirely straight attach the piece to the wall using nails or screws.
Now add your contrasting fringe.
Next stretch it out left and right and place additional push pins there.
Knot a decorative c.
Sew muslin to the top of the rug.
These gaps permit the use of additional brackets and prevent sagging.
Cut a piece of fabric the same width of your rug large enough to be able to form a tube that will snuggly fit the width of your rod.
The second method of hanging an area rug on the wall involves the use of a curtain rod.
Lift the rug and press it into the strap to attach it.
Attach anchors to the wall using a drill and screws.
Repeat until the entire rug is covered in fringe.
This method allows you to hang a fringed rug on the wall without damaging it.
Hot glue another strip about 1 2 to 1 depending on how dense you want the fringe to be above the last.