With the straight edge in place over your mark cut through the surface of the board with the knife.
How to install backer board to concrete floor.
You are only cutting through the fiberglass mesh on the surface.
Add a layer of 1 2 in.
Then spread thinset mortar with the flat side of a 1 4 in.
Using the trowel spread adhesive and ridge it with the notched side of the trowel.
Measure and cut the cement board to fit in around the whole sheets.
With the plywood in place install the backer board as you normally would.
These convenient panels of cementitious board provide an instant flat hard surface that bonds with the thin set adhesives or mortars used to install tile.
Next place a sheet of the backer board over the wet adhesive.
The plywood adds stiffness and stability to the floor.
Leave 1 8 inch between sheets and cuts.
Bc plywood over the old subfloor using construction adhesive and driving 1 1 4 in.
Add more mortar as necessary to fill sunken areas in.
The various brands of cement board such as hardiebacker durock denshield and wonderboard have become a standard tile backer material for nearly all ceramic porcelain and stone tiles for floor wall and countertop applications.
Screws every 6 in.
Remember that it is best when joints in the backer board are not aligned with the joints in the subfloor.
Lay the backer board according to the manufacturer s instructions.
Spread the mortar to about 3 16 thickness.
Use a chalk line to mark the dimension of the backer board sheets onto the floor.
Precut and fit all the cement board and then lift all of the cement boards out.
Notched trowel and use the notched edge to comb the mortar.
There is no need to install backer board on a concrete substrate ceramic tile can be applied right over concrete provided the surface is flat smooth and free of significant cracks.
Do a dry run and lay the backerboard down to fully cover the area you plan to tile.
Plan the placement of the cement backerboard sheets.
Plan so the joints in the backerboard won t line up with the joints in the subfloor.
For highly wet areas such as showers and bathtub surrounds cement board typically is attached directly over the wall studs and the studs may be covered with an intervening moisture membrane.
The backerboard should completely cover the subfloor joints.
Cement board screws spaced every 4 in.