Come back later after the floor has been installed and use a circular saw to cut across for a precise cut.
How to install hardwood floor using regular nails.
Hardwood floors are durable beautiful and a great diy project.
You can use a nail gun for hardwood floor but the question is how you can use it safely.
Set nails as you go.
Since there are various factors and aspects to consider you need the right nail gun so that you can work and finish on time instead of using the time consuming.
Here s how to install flooring using the nail down method.
Always check with the manufacturer s instructions to determine if your hardwood floor can be installed over an in floor radiant heat system.
Solid hardwood flooring only can be installed on or above ground level with a plywood subfloor.
Again follow nwfa guidelines for sanding and finishing but keep in mind the following procedures that make these floors a little different.
Hardwood floor nailer to test out which they claim is specifically designed to install brittle tongued flooring.
Made specifically to fit over the top edge of the plank and the tongue this nailer shoots a headless nail through the tongue and into the subfloor or the floor joist beneath.
Engineered flooring can be installed above grade at grade and below grade level do not install hardwood flooring in bathrooms.
I can t emphasize this enough.
When installing up to a threshold it is not critical to make cuts exact.
One of the best nailers to use to install a hardwood floor is a pneumatic flooring nailer or stapler.
You need to know what to use where since there are many things that your floor will require.
Align the first board with the layout line with the tongue facing into the room.
Used when installing solid hardwood nail down installation is chosen due to how quickly and cost effectively it can be done.
This nailer is much smaller than a traditional hardwood flooring nailer and doesn t require a mallet to hit the nail gun and shoot the nails.
Using the pneumatic nail gun place the gun lip over the edge of the board and strike firmly with the mallet driving the staple into the tongue of the hardwood plank.