5 keep the drill cool while drilling through the tile by dipping it into water frequently.
How to install shutter anchors through tile floor.
8 set the cabinets on the wooden frame and align flush with the framing lumber.
Use the screwdriver to insert the anchor screw.
Repeat for other shutters.
Typical drive in plastic anchors require a 1 4 or 5 16 inch 0 6 or 0 8 cm hole molly anchors and other expansion anchors may require larger holes to allow them to expand properly.
The anchor will be flush with the tile once fully inserted.
Use a hammer to gently tap the fasteners to snug the shutter to the siding.
Finish installing the screw with a screwdriver until it is flush.
The anchor screw should be the same size as the screw you will be using.
Place the anchor screw in the pilot hole.
A correct rod placement is when your curtain rests just above the floor or so that when the shower is running all of the water is contained in the shower area.
Overtightening fasteners during shutter installation can create warping or dimples on the surface of vinyl shutters.
A smaller or larger anchor screw will simply cause the screw to either break the tile or fall from the anchor.
An alternative to drilling into your tile is to use a tensioned shower curtain rod.
Step 3 installing the anchor screw.
Insert the screw into the anchor and twist a few times so it will stay.