This transition strip is designed for joining a laminate floor to a tile floor.
How to install wood transition strip on concrete floor.
Long runs of hardwood floors need to allow for expansion and contraction.
How to install transition strips.
Although the most common transition for t molding is doorways another function of t molding is joining hardwood floors in large areas.
If you are installing laminate or hardwood you will most likely need to put some transition strips down at some point.
Transition strips are used to finish hardwood and laminate floor edges where the product meets an existing floor in a doorway and are typically cut to fit and then nailed in place or snapped into a track that has been screwed to the floor.
When you re working on a concrete floor the installation of transitions is different from the way it s.
Also be absolutely sure that the concrete doesn t get damp because of exterior water problems.
Ceramic tile floors tend to be higher than laminate floors because tile is installed over cement board while laminate usually lies over a thin foam underlayment.
Lay 6 mil polyethylene.
You use nails to nail the strip to the floor.
If you install end cap molding next to brick tile or concrete caulk the gap between the transition strip and the flooring.
When you need to secure the transition strip to concrete however you must use.
A carpet transition strip is the metal strip used to transition from carpet to wood flooring or from carpet to tile.
These can finish off the edge of a floor and make the job look much more professional.
Any floor longer than 40 feet 12 2 meters should have an expansion gap and this is where a t molding would do the job.
Installing transition strips is an often overlooked part of the installation of hard surface flooring.
In this tutorial we show you how to join floors of both equal and unequal heights together with oak transition strips.
Usually the strip is brass or some other type of metal.