To avoid damage to the wall place a board behind the pry bar.
How to lay last few rows of flooring.
I got to the last few rows and used the 16g nailer where the flooring nailer couldn t be used.
When you install the hardwood floors and get to the other side of the room you may have to cut the boards down the length to finish the last row.
Previous mryoucandoityouself video https youtu be z gg56guzwm th.
Some locking systems will not allow you to connect the long side first and then tap the end joint together.
I started laying the hardwood yesterday afternoon today.
To calculate the width needed for the first and last row add the width of a full plank to the width needed for the last row.
If the last row is going to be less than 3 1 2 inches wide consider distributing the width needed between the first and last rows.
I have been on the same complete gut reno addition since i started with the company.
Divide that number by two and cut each plank in the first and last row to that width.
Not all laminates will allow you to install the plank in this manor.
The last rows are blind nailed by hand.
Use the straightest boards available for the last rows.
Connect the joint and as you tap on the pull bar push the plank down and keep moving from one end to the other until the plank is laying flat.
Nail down close to a wall.
Then face nail each row on floor joists joists having already been marked on wall.
Pull rows tight with pry bar tapping lightly with mallet to pull tighter.
The flooring may need to be pried into place.
Then last row ripped on table saw to desired width leaving expansion room but close enough to be covered by trim then pull last row tight with pry bar and face nailed like the rest.